Heat pumps
AC repair
Furnace & heating
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox heat pump service in North Las Vegas that ends a failed part costs $150 – $650 for repairs, and we can usually match your Lennox model number and get the right part the same day. We install Lennox-compatible parts – OEM or a proven equivalent – and we’ll hand you a written price before we touch the system. Most owners call because the heat pump stopped heating, the compressor won’t kick on, or the fan runs but nothing happens. North Las Vegas homes run heat pumps hard through the summer, and the parts that fail first usually do so around a call-out we get regularly.
Which Lennox Models This Applies To
Lennox heat pumps reach across its Merit, Elite and Dave Lennox Signature series, and the parts we replace most often – defrost control boards, reversing valves, run capacitors, contactors, sensors and the accumulator filter – differ by series and by tonnage. Before we order anything, we pull the model and serial plate from the outdoor unit (usually inside the corner panel, sometimes behind the fan guard) and match it to a parts reference, because Lennox changed reversing valve coil voltage and defrost board layouts between series. Sizing matters too: a capacitor rated for a 3-ton unit won’t hold up in a 4- or 5-ton install under our load in North Las Vegas homes.
Decide OEM or aftermarket on the parts that matter. A Lennox OEM reversing valve or control board is the safest fit and carries a manufacturer warranty, and for anything inside the refrigerant circuit we lean OEM. Run capacitors, contactors and pressure switches have solid, spec-matched equivalents that cost less. We’ll tell you which side each part falls on before you decide, and we never claim to pull Lennox brand parts from local stock – we source them the right way.
Signs Your Lennox Heat Pump Service Is Failing
Heat pump failures announce themselves in small ways first. These five are what we see most in North Las Vegas, and the cause behind each one:
- AUX heat runs constantly, no heat pump heat: the reversing valve isn’t switching or its coil has failed, so the system falls back on electric backup strips and your bill jumps. You’ll notice it most on cool desert mornings.
- Outdoor fan runs, compressor is silent: usually a failed contactor or a start capacitor that can’t deliver the jolt. If the compressor hums and trips the breaker, the start components need testing before you replace anything bigger.
- Unit ices over in heating mode: the defrost control board isn’t initiating a defrost cycle, so frost builds and stays. A short defrost cycle or no defrost at all is your sign the board or a sensor failed.
- Frost forms and never clears, or the coil runs cold in cooling: low refrigerant from a leak at a Schrader valve or flare fitting, or a stalling reversing valve. This one is easy to confuse with a defrost fault.
- Breaker trips after a few minutes: a failing run capacitor or a grounded compressor component. Stop running it – a tripping breaker on a heat pump is a warning, not a quirk.
If you’re seeing two or more of these, the system needs a proper diagnostic before you spend on parts. Replacing a capacitor when the real fault is the reversing valve burns money you don’t need to spend.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Replacement Cost & What’s Included
Installed parts on a Lennox heat pump in North Las Vegas land in a $150 – $650 range for most repairs, and you’ll get the written price before any work starts. Here’s what drives the number:
- Part cost and availability: a capacitor or contactor is on the low end; a reversing valve or control board pushes toward the high end and depends on whether we source OEM or a spec-matched equivalent.
- Refrigerant circuit work: anything that opens the sealed system adds recovery, brazing and recharge, which is why reversing valve swaps cost more than a swap-out of a component.
- Access and unit condition: a tight corner install or a unit packed with desert grit takes longer. We factor labor honestly rather than padding the part.
- Labor and testing: every repair includes a run test through a heat and cool cycle so you know the part actually solved the problem.
Every job is backed by our 365-Day Done Right Promise. If a part we installed fails inside that year, we make it right, no runaround and no fine print.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check a few things yourself: flip the breaker off and on, look at the outdoor unit for ice or debris, and confirm the thermostat isn’t set to emergency heat. Beyond that, stop. A heat pump runs 240-volt power into the contactor and the compressor circuit, and capacitors hold a charge even after the breaker is off. Swapping a reversing valve means recovering refrigerant under pressure, and that’s not a homeowner job. The parts that fail most aren’t dangerous to identify, but they are dangerous to handle.
If your system needs more than a visual check, call (844) 320-2997. A live person answers 24 hours a day, and we’ll tell you plainly whether it’s a part you can wait on or one we should handle today.
FAQs
Most Lennox heat pump service parts we replace last 8 to 15 years in a normal climate, but North Las Vegas heat is brutal on capacitors and contactors, which often fail between 5 and 10 years because of the summer duty cycle. The compressor and reversing valve typically outlast the electrical components. When you replace a part, we tell you the realistic lifespan for your model and duty cycle, not a generic number.
Sometimes, yes. Capacitors and contactors are replaced, not repaired, because they’re sealed components. A defrost control board can occasionally be reset and tested, but if it repeats the fault the board is done. Reversing valves can be rebuilt in some cases, though on a smaller Lennox unit the labor often makes a new valve the better call. We diagnose first and recommend what actually fixes it.
A straightforward part swap on a Lennox heat pump takes about 1 to 2 hours, including the diagnostic and the run test. A sealed-system repair like a reversing valve runs 3 to 5 hours, and we’ll quote the time before we start. Same-day availability is common, especially during cooling season in North Las Vegas.
We pull your model and serial plate, match it to the Lennox parts reference for your series and tonnage, and order OEM or a spec-matched equivalent with your approval. We don’t keep a stock of Lennox parts on a truck; we confirm the correct fit and source it for your system. If a part is backordered, we’ll tell you so and offer a compatible alternative when one exists.
Get Your Lennox Heat Pump Fixed Right
If your Lennox heat pump is cooling poorly, stuck on emergency heat, or tripping the breaker, give us a call. We’ll diagnose the actual failed part, quote the repair with the written price in hand, and walk you through OEM versus equivalent before anything is ordered. We also service Carrier and Trane equipment, so if you have more than one system in the house, one visit can cover it.
Meadowsweet Heating & Air North Las Vegas is an independently owned and operated location within the Cedarwell family of HVAC companies. We’re not affiliated with Lennox; we’re an independent service provider qualified to work on Lennox equipment. Every visit includes a live answer, shoe covers and drop cloths, and a photo of the clean-up before the crew leaves. Call (844) 320-2997 for a free estimate.
Written by the team at Meadowsweet Heating & Air North Las Vegas, serving North Las Vegas and nearby areas.