A Meadowsweet company - serving North Las Vegas, NV

Lennox Mini-Split Installation in North Las Vegas, NV

Ductless mini splitsDuctless mini splits
AC repairAC repair
Furnace & heatingFurnace & heating
Heat pumpsHeat pumps
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Lennox Mini-Split Installation: The North Las Vegas Owner’s Guide

We install Lennox mini-split systems in North Las Vegas, with a typical installed cost of $3,500 – $7,500 for a single-zone setup depending on capacity and line-set length. Because this is scheduled work, not an emergency service, we give you a written fixed price and a set install date rather than promising same-day. Most North Las Vegas owners arrive at this page after noticing something slightly off: a ductless head that cools one room well and the next room poorly, a unit that runs but never seems to reach the setpoint, or a system that was quoted by a big-box installer with the wrong line-set length and has never quite worked right since.

Call (844) 320-2997

Which Lennox Models This Applies To

Lennox sells ductless equipment under its mini-split and multi-zone lines, and the practical detail that trips people up in North Las Vegas is that the indoor head and the outdoor condenser must be a matched pair from the same series. A head from one series will bolt up and even power on with a condenser from another, but it will cycle wrong and lose efficiency, and it can void the manufacturer’s coverage on both pieces. Check the data plate on the side of the outdoor unit and the sticker under the indoor head’s front panel. The model number tells you the series, the nominal capacity in thousands of BTUs, and the voltage. Bring us clear photos of both plates and we’ll confirm the match before anything is ordered.

On the OEM-versus-aftermarket question: for the condenser, the indoor head, and the line-set connections, we source genuine Lennox parts because the refrigerant circuit has to match exactly. For consumables like filter media, mounting hardware, and drain components, quality aftermarket equivalents are fine and cost less. We don’t carry parts on a truck and we don’t claim to stock anything locally; parts are ordered to your specific model, which is why we ask for the data-plate photos first. We also handle Carrier and Trane equipment, so if you’re comparing brands we can talk through the fit honestly. We’re an independent service provider, not affiliated with Lennox.

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Signs Your Lennox Mini-Split Installation Is Failing

Ductless systems usually don’t fail all at once. They degrade in ways that are easy to write off as weather. In North Las Vegas, with summer highs that hold above 100°F for weeks and dust that finds every seam, these are the signals we see most:

  • One zone cools well and the others don’t. This is usually a refrigerant charge issue or a line-set length that was miscalculated at install. When the original installer assumed a shorter run than the actual distance, the charge is wrong from day one and no amount of thermostat adjustment fixes it.
  • Ice on the indoor coil or the outdoor line. Frost or ice means low refrigerant or restricted airflow. In our climate, a clogged filter is the frequent culprit, but a slow leak is the other possibility and it needs a pressure test rather than another filter change.
  • Water dripping from the indoor head. The condensate drain is clogged or pitched wrong. North Las Vegas dust and the occasional monsoon humidity both accelerate drain buildup, and a drain that was run with too little fall will back up repeatedly.
  • The outdoor unit short-cycles. It starts, runs a few minutes, stops. This points to a control board, a sensor, or an overcharge. Short cycling is hard on the compressor and gets more expensive the longer it runs that way.
  • Rattling, humming, or a grinding noise from the condenser fan. Fan motor bearings or a loose blade. A grinding fan is worth shutting down and calling about, because a seized motor can damage the board that drives it.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Mini-split installation in North Las Vegas runs $3,500 – $7,500 installed for a single-zone system, and multi-zone setups price higher because each additional indoor head adds equipment, line-set, and labor. Here’s what drives where you land in that range:

  • Capacity: a small single-room head sits near the bottom; a system sized for an open living area with west-facing glass sits higher.
  • Line-set length and routing: a short run through an exterior wall is simple; a long run across a garage or attic, or through finished walls, adds labor.
  • Electrical: a dedicated circuit and disconnect may be needed, and that’s quoted separately and clearly before we start.
  • Mounting: wall bracket versus ground pad, and whether the pad needs a stand to keep the condenser clear of flood irrigation runoff.

On pricing, our standard applies: a written price before any work starts, on every visit, every time. You’ll know the parts cost and the labor cost, not a bundled mystery number. Every installation is backed by our 365-Day Done Right Promise. If it isn’t done right, we make it right, with no fine print.

For comparison, AC repair runs $150 – $650 and a tune-up is $80 – $200. If your existing system is limping along, a tune-up is often the cheaper first step before we talk about replacement.

DIY or Call Us?

There’s a real line here, and it’s worth being honest about. What you can safely do yourself: pull the indoor head’s front panel and clean or replace the filter, clear visible debris from around the outdoor condenser, and confirm the unit is getting power at the breaker. Some owners can also rinse a drain line if the access is easy and the pan is reachable.

What you should not do yourself: anything that opens the refrigerant circuit. Mini-splits run on refrigerant under pressure, and connecting line-sets, brazing, evacuating, and charging require recovery equipment, a vacuum pump, and gauges. Releasing refrigerant is a safety issue, a legal issue, and it’s the most common way a DIY mini-split ends up costing more than a professional install. Electrical work on the dedicated circuit and disconnect is the second. If you’re unsure which side of the line you’re on, call us at (844) 320-2997 and describe what you’re seeing. No pressure either way.

FAQs

Need HVAC help nationwide? Licensed & insured · 60-minute response · free estimates
Call (844) 320-2997
Local Service Coverage

Request a Free Estimate in North Las Vegas

Tell us what you need - Meadowsweet Heating & Air North Las Vegas responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch